Loading ...
Loading ...
Loading ...
EN - 16
2. Route the untied end of rope through the
two eye bolts. See Figure 24.
3. Route the rope through the right bagger
arm eye and tie a knot. See Figure 25.
NOTICE: Installation kit must be installed with
bagger prior to operation. See Installation Kits
on page 19.
4. Reconnect spark plug wires.
BEFORE EACH USE
1. Check bagger parts for wear damage.
Replace ONLY with Ariens or Gravely
original service parts before operating.
2. Ensure counterweights are installed.
3. Ensure all hardware is tight.
IMPORTANT: Check belt-cover hardware
often. Tighten as needed.
4. Remove any grass buildup from bagger
parts.
5. Ensure hose is installed correctly.
6. Ensure mesh bags are installed and the
bagger cover is closed and securely
latched.
BAGGING
Starting
1. Start engine and engage PTO according
to unit Operator’s Manual.
2. Set throttle to full speed.
3. Choose a slow ground speed.
Stopping
1. Disengage PTO.
2. Stop unit according to unit Operator’s
manual.
Emptying Mesh Bags
If bagger stops collecting grass clippings,
mesh bags are likely full.
1. Disengage PTO, stop engine and remove
ignition key. Wait for all moving parts to
stop before leaving operator’s position.
2. Empty the grass from each bag.
3. Clean out hose.
4. Close and latch cover.
Figure 24
Figure 25
OPERATION
WARNING: AVOID INJURY.
Read and understand entire
Safety section before
proceeding.
WARNING: Counterweights
MUST be installed before
operating unit with bagger. See
Installation Kits on page 19.
WARNING: Stop engine and
remove key. DO NOT park on
slopes.
Loading ...
Loading ...
Loading ...