Loading ...
Loading ...
Loading ...
17CARE AND CLEANING
NOTE
1. Check the seal between the hose and the
drain connector. If there is a small leak
then replace the hose gasket and
re-tighten the hose.
2. It is recommended that a Dehumidifier
Drain Hose - 1/2" (12.7 mm) or larger be
used. Make sure there are no kinks or
elevations in the hose.
3. When a hose is not attached to the drain
connector, please ensure drain cap is
screwed securely to the connector to
prevent leakages.
Care and Cleaning
3. Pump function:
To connect pump drain hose:
a. Press the tightening ring of drainage
joint;(fig.11)
b. Keep pressing the grey ring while pulling
out the plug. (fig.12);
c. Insert the drain hose onto the drainage
joint, make sure it is connected well so that
it is fully seated.
d. Place the other end of the drain hose in the
location you want the water to go to a floor
drain, a water container, or through a
basement window to the outdoors.
NOTE:
1. The maximum distance and the rise may
be 5m from the unit. Exceeding this
distance may damage the unit or cause
leaks.
2. If removing the hose to use in Bucket
mode, please reinsert the drain plug to
prevent accidental water leakage. (You
still need to press the tightening ring
when removing the hose.)
To remove pump drain hose:
a. Press the tightening ring of drainage joint.
b. Pull out the drain hose.
c. Place the plug back to the joint.
1 2
fig.11
3 4
fig.12
b. Detach the filter from the back of the grille
by pressing the tabs as shown below.
1. Filter
Clean the filter every two weeks based on
normal operating conditions.
To remove the filter:
a. Open the back grille.
Loading ...
Loading ...
Loading ...