Loading ...
Loading ...
Loading ...
13OPERATING INSTRUCTIONS
3. After a few days when the Relative
Humidity has declined, press the HUMIDITY
( ) or ( ) buttons to choose a value
between 35% to 85%, so the room is kept
at a comfortable humidity. Pressing the
( ) or ( ) buttons will change the
humidity selection in 5% increments. 5
seconds after you have set the desired
humidity, the readout will display the
actual room humidity. If at any time you
want to return to the CONTINUOUS Mode,
pressing the HUMIDITY ( ) button will
lower the Relative Humidity through 5%
decrements until the display reads CO.
4. You can also use the FAN SPEED button to
change the fan speed to Hi, Med or Lo. The
indicator light will show the setting you
have selected. A higher fan speed will
result in quicker moisture removal.
5. The Filter reset light will illuminate after
250 hours of operation. At this time refer
to the care and cleaning section to remove
and clean the filter. Once the filter has been
cleaned and replaced, simply press the
Filter reset button to extinguish the light.
6. The TIMER function enables you to either
Delay Start or Delay Stop the unit in the
choice from 0.5 hour to 24 hours. If the unit
is running, then selecting Timer will turn
the unit o in the hours that will be set
(Delay Stop). If the unit is o, then
selecting Timer will turn the unit on in the
hours that will be set (Delay Start). TIMER
setting: First press TIMER button, then
adjust timer setting, by tapping or holding
the ( ) or ( ) button to change the delay
timer at 0.5 hour increments, up to 10
hours, then by 1 hour increments up to 24
hours. The control will count down the time
remaining (8h, 7.5h, 7h etc.) until the unit
either starts or stops. For the Delay Start,
the fan speed and humidity maintained will
be the same as previous setting. After
TIMER setting finishes, pressing TIMER
button again at any time will stop the
TIMER function. The Delay Start/Stop
Feature will work until the unit either starts
or stops. Once that happens the above
steps have to be repeated.
NOTE
1. Before entering TIMER setting, make sure
power is being supplied to the unit.
2. Before entering TIMER setting, make sure
pressing HUMIDITY ( ) or ( ) button
sets one desired room humidity first.
7. Press PUMP button, the unit will enter
water pump mode. Pump Mode Indicator
will be on. When the water tank is full of
water, the pump will start to pump water
automatically. The pump will stop
automatically after the water tank have
been empty.
Loading ...
Loading ...
Loading ...