Loading ...
Loading ...
Loading ...
12
Operation
Water drainage
Continuous Drainage for DRY mode
- Remove the upper drain plug
from back of unit.
"
- Attach drain connector (5/8
universal female mender) to
a 3/4" hose (not included,
purchase locally). Connect
to spout. For models without
the drain connector, just
attach drain hose to spout.
- Position the open end
directly over drain area.
Continuous Drainage for HEAT mode (required)
(Heating models only)
- Remove the lower drain plug
from the back of the unit.
- Attach drain connector (5/8"
universal female mendor) to a
3/4" hose (not included, purchase
locally). Connect to spout.
- Position the open end directly
over drain area.
- The continuous drain for Heat
mode has a built-in pump,
maximum height for the drain
hose is 5 feet.
NOTE: Make sure connection is secure to prevent leakage.
Direct the hose towards the drain, making sure there are
no kinks that may stop the water flow. Place the end of the
hose into the drain and make sure the end of hose is down
to let water flow smoothly.
When continuous drain is not used, be sure the
corresponding drain plug and knob are firmly installed in
Emptying the Water Tank
When the water in the bottom tray reaches its maximum capacity,
the unit will beep 8 times and display will show "P1". At this time,
the compressor will immediately stop but
fan will continue to operate.
- Place a collection pan underneath
the bottom tray drain spout or
carefully move the unit to a drain
location.
- Remove the bottom drain plug and
water will begin to drain out.
- Replace the drain plug and restart
unit. P1 indicator should disappear.
Remove the
upper drain plug
√
Continuous
drain hose
√
drain hose
adaptor
Continuous
drain hose
Remove the
lower drain plug
√
delivery lift <1.8m
drain hose
adaptor
drain hose
adaptor
X
Loading ...
Loading ...
Loading ...