Loading ...
Loading ...
Loading ...
2. Rest the front shoe of the saw on the work piece.
3. Start the saw on the work piece.
NOTE
Make sure that the blade is not contacting the work
piece.
Flush cutting
1. The compact design of the machine permits close
cutting to floors, corners and other difficult areas.
2. To maximize flush cutting capabilities, insert the
blade shaft into the blade clamp with the teeth of
the blade facing up.
3. Turn the saw upside down so you are as close to
the work surface as possible.
Wood cutting
1. Before cutting any type of wood, be sure the work
piece is firmly anchored or clamped to prevent
slipping.
2. Place blade and shoe lightly against work to be cut.
3. Switch on saw motor before applying pressure.
Metal cutting
1. In thin gauge sheet metals it is best to clamp wood
to the underside of the sheet. This will ensure a
clean cut without excess vibration or tearing of
metal.
2. Avoid forcing cutting blade as this reduces blade life
and causes costly blade breakage.
Pocket cutting
1. Measure the surface area to be cut and mark clearly
with a pencil, chalk or scriber.
2. Insert blade in blade clamp and tighten blade clamp
securely.
3. Tip the saw backward until the bottom edge of the
shoe is resting on the work surface.
4. Switch motor on, permitting blade to attain
maximum speed.
5. Grip handle steadily and begin a slow, deliberate
upward swing with the handle of the saw.
6. The blade will begin to feed into material. Always
be sure blade is completely through material before
continuing with pocket cut.
9
English
EN
Loading ...
Loading ...
Loading ...