Loading ...
Loading ...
A3/8"airhoseisrequireduptoalengthof8ft.
Ifmorelengtt_isrequired,a1/2"airhoseshouldbe
connectedtothe3/8"hosetoensurethetoolhasthe
necessaryairsupply.Besureallhosesandfittings
arethecorrectsizeandtightlysecured.
WARNING:DISCONNECTTOOL FROM AIR
SUPPLY BEFORE SERVICING OR CHANGING
DISCS.
PLEASE NOTE: USE ONLY CUT-OFF WHEELS
RATED AT OR ABOVE 20,000 RPM ONLY (SEARS
ACCESSORY 18834). THE CUT-OFF WHEEL MUST
HAVE A 3/8" CENTER HOLE. NEVER OPERATE
THIS TOOL IF GUARD IS BROKEN OR REMOVED.
Always disconnect tool from power supply before
changing accessories. Never hold work in hands, lap
or against other parts of the body. Secure all work with
clamps or a vise so that both hands are free to
operate tool. Keep proper footing and balance at all
times. Do not force tools, allow tool to work at
designed pace.
In the event that it becomes necessary to store the
tool for an extended period of time (overnight,
weekend, etc.), it should receive a generous amount
of lubrication at that time. The tool should be run for
approximately 30 seconds to ensure oil has been
evenly distributed throughout the tool. The tool should
be stored in a clean and dry environment.
Recommended lubricants: Use air tool oil or any
other high grade turbine oil containing moisture
absorbent, rust inhibitors, metal wetting agents and an
EP (extreme pressure) additive.
Specifications
Speed ..................................................... 20,000 RPM
Wheel size ................................... 2-7/8" x 1/16" x 3/8"
Arbor size ............................................................ 3/8"
Length .................................................................... 7"
Weight ........................................................ 1-3/4 Ibs.
Air inlet ....................................... i................. 1/4" NPT
Hose size ...................................................... 3/8" I.D,
Average air consumption ................................ 4 CFM
Maximum air pressure .................................... 90 PSI
Lubrication
An automatic in-line filter-regulator-lubricator is
recommended as it increases tool life and keeps the
tool in sustained operation. The in-line lubricator
should be regularly checked and filled with air tool oil.
Proper adjustment of the in-line lubricator is performed
by placing a sheet of paper next to the exhaust ports
and holding the throttle open approximately 30
seconds. The lubricator is properly set when a light
stain of oil collects on the paper. Excessive amounts
of oi! should be avoided.
x
x x x
x x x
X
X
Check air pressure
Check for water in lines
Oil tool with air tool oil
(3)
Loading ...
Loading ...
Loading ...