Loading ...
Loading ...
Loading ...
13
2. The chute deector on the top of the discharge chute
controls the height of the snow stream. Loosen the knobs
to raise or lower the deector to the desired height of
snow you wish to throw. Tighten the knobs to secure the
deector (Fig. 14).
Maintenance
To order genuine replacement parts or accessories for the
Snow Joe
®
24V-X2-SB15 cordless snow blower, please visit
snowjoe.com or contact the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
Lifetime Lubrication (Motor + Auger)
Lubrication is not necessary and may damage the unit.
The snow blower is lubricated for lifetime use at the factory
before shipment.
General Maintenance Tips
mWARNING! Always switch the product o, remove
the batteries, and let the product cool completely before
inspecting, cleaning, or performing any other maintenance
task.
mWARNING! Only perform the repairs and maintenance
work described in this manual. Any other work must be
performed by a qualied technician.
1. Do not attempt to repair the machine unless you have the
proper tools and instructions for disassembly and repair of
the machine.
2. Check bolts and screws at frequent intervals for proper
tightness to ensure that the equipment is in safe working
condition.
3. After each snow removal session, run the snow blower
for a few minutes to prevent the collector/impeller from
freezing. Shut o the motor, wait for all revolving parts to
stop completely, and wipe residual ice and snow o the
unit. Rotate the chute deector several times to remove
any excess snow.
Replacing the Scraper Blade
IMPORTANT: Only use original replacement parts specied for
this snow blower.
You can purchase a replacement scraper blade (Model
24V-X2-SB15-SCBLADE) and other genuine replacement parts
by visiting us online at snowjoe.com or calling our toll-free
customer service helpline at 1-866-SNOWJOE
(1-866-766-9563). The use of parts that do not meet the
original equipment specications may lead to improper
performance of the snow blower, may compromise operator
safety and will void the manufacturer's warranty.
1. Turn o the snow blower, remove the batteries and wait
until the snow blower comes to complete standstill.
2. The scraper blade is located at the base of the snow
blower beneath the auger housing. Detach the worn
scraper bar from the snow blower by removing the 3
screws that hold it in place (Fig. 15).
3. Install the new scraper blade and fasten it securely to the
snow blower with 3 screws (Fig. 15).
Replacing the Auger Blades
IMPORTANT: Only use original replacement parts specied for
this snow blower.
You can purchase a replacement auger blade (Model
24V-X2-SB15-AUGER) and other genuine replacement parts
by visiting us online at snowjoe.com or calling our toll-free
customer service helpline at 1-866-SNOWJOE
(1-866-766-9563). The use of parts that do not meet the
original equipment specications may lead to improper
performance of the snow blower, may compromise operator
safety and will void the manufacturer's warranty.
NOTE: When replacing worn auger blades, pay close attention
to any dierent types of bolts, washers and nuts and where
they are positioned. This will ensure that all parts are installed
properly and securely.
Fig. 14
Chutedeector
Chute
deector
knob
Fig. 15
Scraper blade
Screws
Loading ...
Loading ...
Loading ...