Loading ...
Loading ...
Loading ...
www.SereneLifeHome.com
13
Remove the blade 1 along 45° direction (Fig.4b).
To insert the blade 1, Be careful not to allow any foreign matter to become
attached to the blade gear and do not damage it. First Insert part of the tooth
of the blade 1 into the case as shown(Fig.4c), then rotate the blade 1until the hole
of the blade 1 is aligned to the hole of the aluminum gearbox. Incorrect location
of the blade will damage the machine. Ret the blade screw then ret the washer
8 and the wave washer 9, at last tighten the blade nut 11. Do not over tighten.
7. Cleaning, maintenance and ordering of spare parts
Warning! Always wear protective gloves when using, adjusting or cleaning
the machine.
7.1 Cleaning
• Keep all safety devices, air vents and the motor housing free of dirt and dust as
far as possible. Wipe the equipment with a clean cloth or blow it with compressed
air at low pressure.
• We recommend that you clean the device immediately each time you have
nished using it.
• Clean the equipment regularly with a moist cloth and some soft soap. Do not use
cleaning agents or solvents; these could attack the plastic parts of the equipment.
Ensure that no water can seep into the device.
• A few drops of oil (e.g. sewing machine oil)will improve the cutting performance
of the blades, but never apply any grease to the blades.
Important!
Never clean the tool under running water- and particularly never with high
pressure -because of the potential danger to persons and property. Keep
your cordless pruner in a dry and frost proof place. Choose a place that
children are unable to enter.
7.2 Maintenance
• To achieve good results you should keep the blades sharp at all times. The tool
should be thoroughly cleaned both before and after use.
• There are no parts inside the equipment which require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering replacement parts:
• Type of machine
• Article number of the machine
• Identication number of the machine
Loading ...
Loading ...
Loading ...