SereneLife PSPR170 Cordless Lithium Power Pruner, Pruning Shear with 7.2V Lithium-ion Battery Powered Garden Electric Pole Pruner

User Manual - Page 11

For PSPR170.

PDF File Manual, 16 pages, Read Online | Download pdf file

PSPR170 photo
Loading ...
Loading ...
Loading ...
www.SereneLifeHome.com
11
Battery charger
Mains voltage ......................................................... 120-240 VAC ~ 50-60 Hz
Output
Rated voltage ................................................................................. 9V DC
Rated current: ............................................................................... 400 mA
The vibration emission level has been measured in accordance with a set of
standardized criteria and can be used to compare one power tool with another.
The specied emission level can also be used to make an initial assessment of
the exposure to vibrations.
The vibration emission level may vary from the level specied during actual use,
depending on the way in which the power tool is used.
Try to keep the impact from vibrations as low as possible. Exposure to vibrations
can be reduced by wearing gloves when using the tool, for example, and by
limiting the amount of operating time. This includes the full cycle of operation
(e.g. times when the power tool is switched o and times when the tool is
switched on but no working load is applied).
5. Before starting the equipment
5.1 Installing the battery (Fig. 2a/2b)
Press the both side of the battery pack as shown in Fig. 2a and push the battery
pack into the mount provided. When the battery pack is positioned as in Fig.
2b, make sure that the battery pack latch in place! To remove the battery pack,
proceed in reverse order.
5.2 Charging the battery (Fig.3)
1. Take the battery pack out of the equipment. Do this by pressing the both side of
the battery pack.
2. Check that your mains voltage is the same as that marked on the charger rating
plate. Connect the power plug of the charging unit to a socket outlet, then insert
the charging unit to battery pack. The red LED was always light.
3. The charging unit will end the charging automatically when the battery is fully
charged (after approx. 3~5 hours). The green LED then lights up and the red LED
light out.
The battery pack can become a little warm during the charging. This is normal.
If the battery pack fails to charge, the green and red LED in the battery lights
up. Check:
Loading ...
Loading ...
Loading ...