Loading ...
Loading ...
Loading ...
REPLACINGBATTERY
d_,WARNING:Do notshortbattery
terminalsby allowingawrenchor any
otherobjectto contactbothterminalsat
timesametime.Beforeconnectingbattery,
removemetalbracelets,wristwatchbands,
rings,etc.
Positiveterminalmustbe connected
first to preventsparkingfrom accidental
grounding.
1, Lift hoodto raisedposition.
2. DisconnectBLACKbatterycable(A)
then REDbatterycableand carefully
removebatteryfromtractor.
3, Installnewbatterywith terminalsin
samepositionas old battery.
4, FirstconnectRED batterycable(B)to
positive(+)batteryterminalwith hex
bolt and kepsnutas shown_Tighten
securely.Slideterminalcover(C)over
terminal_
5o ConnectBLACKgroundingcableto
negative(-) batteryterminalwith re-
maininghex boltand kepsnut.Tighten
securely
6. Closehood.
_ Negative
(Black)
Cable
p,"
Positive
(Red)
Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood°
2. Remove bulb holder from the hole in
the backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting,
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood°
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4_ When replacing hood, be sure to re-
connect the headlight wire connector.
Hood
Headlight Wire
Connector
ENGINE
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at
the factory and adjustment should not be
necessary Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, see engine manual.
TO ADJUST CHOKE CONTROL
The choke control has been preset at
the factory and adjustment should not be
necessary. If adjustment is necessary, see
engine manual.
ADJUST CARBURETOR
Your carburetor has been preset at the
factory and adjustment should not be nec-
essary. However, minor adjustment may
be required to compensate for differences
in fuel, temperature, altitude or toad _ If the
engine does need adjustment, see engine
manual.
26
Loading ...
Loading ...
Loading ...