Loading ...
Loading ...
Loading ...
8
Storage
Bottles can differ in size. Accordingly, the actual number of bottles you can store may vary.
The approximate maximum bottle capacity can be achieved when storing traditional 750 ml Bordeaux bottles in
bulk storage.
You may load your wine bottles in single rows or by stacking while taking note of the following: if you do not have
enough bottles to fill your wine cellar, it is better to distribute the load throughout the wine cellar so as to avoid “all
on top” or “all below” type loads.
Do remove or relocate adjustable wooden shelves to accommodate larger types of bottles or increase the
capacity of the cellar by stacking the bottles when necessary. (See instructions for removing shelves, above.)
Keep small gaps between the walls and the bottles to allow air to circulate. As in an underground cellar, air
circulation is important to prevent mold and for a more homogeneous temperature within the cellar.
To facilitate air circulation, do not overload your wine cellar.
Avoid obstructing the internal fans (located inside on the rear panel of the wine cellar).
To prevent bottles from falling, do not try to slide the shelves outward beyond the fixed position.
Do not pull out more than one loaded shelf at a time as this may cause the wine cellar to tilt forward if not
properly installed.
Reversing the Door Swing
This appliance has the capability of the door opening from either the left or right side. The unit is delivered to you with
the door opening from the left side. Should you desire to reverse the opening direction, please follow the instructions
below.
To make the reversal, you will find two hardware pieces in a plastic bag inside the appliance: the top left door hinge
and left bottom door hinge core assembly.
1. Carefully lay the appliance on its back. Use cushioning to protect the floor and appliance.
2. Using a Slotted screwdriver to remove the upper door hinge core at the upper right corner of the door.
3. Using a Philips screwdriver, remove the two screws of bottom right hinge core beneath the door. Keep the hinge
in a safe place in case you need to reverse the door again in the future.
4. Carefully slide the door off and place it on a padded surface.
5. Using a Philips screwdriver, remove the screws from the top right hinge, remove the top right hinge and keep it
in a safe place in case you want to reverse the door in the future.
6. Remove the screws from the top left and transfer to the right.
7. Install the top left hinge.
8. Rotate the door 180° and take out the bottom left door hinge core from Accessory bag, insert it to the door shaft
hole in the lower left corner of the door .
9. Put the door back into the cabinet, and use a Slotted screwdriver to install the door hinge core back to the door
shaft hole in the upper left corner of the door body.
10. Adjust door alignment. When set, tighten screw on hinge.
Carbon Filter
A built-in carbon filter protects your wines by acting as a natural barrier against
harmful odors. The carbon filter should be replaced every 9-12 months
depending on the unit’s exposure level to odor. If the unit is placed in a kitchen,
regular replacement every three months is ideal.
Remove the carbon filter by turning counterclockwise to unlock from rear panel.
Loading ...
Loading ...
Loading ...