Loading ...
Loading ...
Loading ...
\
Lower
Handle
Notch
.
7.
Figure 16
Reassemble the upper handle to the lower handle.
Place the hairpin clips in the inner holes of the weld
pins and replace the carriage bolts and wing nuts
on te handle brackets. Attach the starter rope as
instructed inthe Assembly section.
AdjustingCuttingHeight
An adjusting plate and thumb lever at each wheel
position provides cutting height adjustment. Each
adjusting plate has nine height positions.
1. Simply depress the lever towards wheel and move
itto any of the nine positions for the desired cutting
height. See Figure 17.
2. Place all four levers on the four wheels in the same
relative position for uniformcutting.
Height Adjustment
Lever
AdjustingCarburetor
If the engine is running rough, minor adjustments to the
carburetor may be required to compensate for
differences in fuel, temperature, altitude and load.
NOTE: Dirty air cleaner may cause an engine to run
rough.Before adjusting carburetor, check air cleaner.
To adjust the carburetor, please follow the
recommendations and instructionson carburetor
adjustment in the engine manual.
_ WARNING: If any adjustments are made to
_, the engine (e.g. carburetor) while the engine is
running, keep clear of all moving parts. Be
careful of heated surfaces like the muffler.
AdjustingDriveClutch
The drive clutch adjustment wheel is located on the
lower right handle and is used to tighten or loosen
tension on the drive cable. Adjust this cable if
a. the mower does not propel itself; or
b. the wheels hesitate with the drive control
handle pushed forward.
1. To adjust, rotate the adjustment wheel with your
fingers. See Figure 18 for location of the wheel.
2. Turn the wheel to the left to tighten the drive cable.
Turn the wheel to the right to loosen the drive cable.
Drive Clutch
Adjustment
Wheel
Figure 17 Figure 18
15
Loading ...
Loading ...
Loading ...