Loading ...
Loading ...
Loading ...
Placement of Burner Caps and Trim Rings and Grates
Place grate over burner pans. Make sure that the groove under grate fits over the raised
lip of the burner pan. The rounded corners of the grates should be placed toward the
front of the range for the front burners and toward the rear of the range for the back
burners.
Grate
Surface
Cooking
FEATURE OVERVIEW
Positioning Burner
Grates
• Setting Surface
Controls
lippan
Setting Surface Controls
Your range may be equipped with any combination of the following burners:
Simmer Burner, this burner is best used for simmering delicate sauces, etc.
Standard Burner, can be used for most all surface cooking needs.
Large Burner, the larger burner is best used when bringing large quantities of liquid to
temperature and when preparing larger quantities of food.
Regardless of size, always select a utensil that is suitable for the amount and type of
food being prepared. Select a burner and flame size appropriate to the pan. Never allow
flames to extend beyond the outer edge of the pan.
Each burner lights automatically from an electric ignitor each time a control knob is
turned to the LITE position.
_1_ Do not place plastic items such as salt and pepper shakers, spoon
holders or plastic wrappings on top of the range when it is in use. These items could
melt or ignite. Potholders, towels or wood spoons could catch fire if placed too close to
a flame.
To operate the surface burner:
1. Place cooking utensil on burner.
2. Push the Surface Control knob in and turn counterclockwise out of the OFF
position.
3. Release the knob and rotate to the LITE position. Note: All four electronic ignitors
will click at the same time. However, only the burner you are turning on will ignite.
3. Visually check that the burner has lit.
4. Push the control knob in and turn counterclockwise to the desired flame size. The
control knobs do not have to be set at a particular mark. Use the guides and adjust
the flame as needed. DO NOT cook with the Surface Control knob in the LITE
position. (The electronic ignitor will continue to click if left in the LITE position.)
rl1
Z
r--
m
:3:
In the event of an electrical power outage, the surface burners can be lit manually. To
light a surface burner, hold a lit match to the burner head, then slowly turn the Surface
Control knob to LITE. After burner lights push in and turn knob to desired setting. Use
caution when lighting surface burners manually.
13
Loading ...
Loading ...
Loading ...