Loading ...
Loading ...
Loading ...
803341 - Tap Installation Instructions - 02.17 - v2.02 Page 9 of 20
Cut a 50mm hole in the bench / sink top.
SINK TOP
4.1
50mm
Note
Note: make sure the tap location will allow the
nozzle to drain into the sink. (See Page 11)
4 - Classic All-In-One Tap
Installation
Min 300mm335mm
470mm
4.2
• Fit the seal ring to the base
of the tap and If mounting on an uneven surface, apply
a light smear of silicone
sealant to ensure a watertight seal
• Mount the tap on top of the cut out hole after passing the usb cable and tubes through the 50mm hole
• Thread the cable and silicon tubes through the circular clamp block (Check the tube colour alignment with the
coloured dots on the clamp block). (See fig 1.16)
• Clamp the assembly in position using the threaded nut and clamp block
• Working from inside the cupboard, attach the braided hoses to the tube extensions (ensure the seals on the end of
the hoses are lubricated). Check the correct position for Hot and Cold connections by matching the colours on the
braided hoses with the coloured markings on the copper extension tubes. (See fig. 1.18)
• Test for leaks after all the connections have been secured.
Installation Procedure
Loading ...
Loading ...
Loading ...