Loading ...
Loading ...
Loading ...
7
INSTALLATION INSTRUCTIONS
• Remove all packing materials, including the bottom cushions, foam pads, and tape inside
the freezer/refrigerator. Tear off all protective film on the doors and on the
freezer/refrigerator body.
• Place the freezer/refrigerator in a well-ventilated place, on flat sturdy ground.
• Avoid locating the freezer/refrigerator in moist or humid areas. Excess moisture in the air
may cause frost to form quickly on the evaporator and cabinet, requiring frequent
defrosting. Locate the freezer/refrigerator away from direct sunlight and other heat
sources. Direct sunlight may affect the performance of the appliance.
• The freezer/refrigerator should be placed against the wall with at least 4” (10cm) of free
space to allow for heat dissipation. There should also be at least 11” (30cm) of space
above the appliance, as well.
Installing Your Appliance in a Garage
• As a freezer, this unit can be installed in a well-ventilated area inside a garage where
the ambient temperature is between 0°F (-17.7°C) and 110°F (43.3°C).
• If you are using this unit as a refrigerator in a garage setting, the ambient temperature
must be above 38°F (3.3°C)
Before Using your Appliance
1. Keep the freezer/refrigerator upright for half an hour before connecting it to the power supply.
2. Connect the appliance to a power supply, and let the unit run for 2-3 hours.
NOTE: If the ambient temperature of the room is higher than normal (starting the machine in the
summertime, for example), it may take up to 4 hours to start using the appliance.
Leveling the Appliance
Use the leveling feet to ensure the appliance does not wobble or tip.
• Turn the feet clockwise to raise the unit and turn the feet counterclockwise to lower the unit.
CAUTION: Do not place any additional appliances, such as a microwave, on top of the unit unless
expressly recommended by the manufacturer.
Moving the Appliance
Remove all objects from the appliance before moving. Affix the glass partitions, vegetable holder,
and freezing chamber drawers with tape. Tighten the leveling feet, close the doors, and affix them
with tape. Keep the appliance inclined by more than 45°. DO NOT lay the appliance on its side or
upside down.
Loading ...
Loading ...
Loading ...