Loading ...
Loading ...
Loading ...
1_ Unplug cord from wall outleL DO NOT
drip water on cleaner.
2. Clean exterior using a clean, soft cloth
that has been dipped in a solution of mild
liquid detergent and water, then wrung dry
Wipe dry after cleaning.
3. To reduce static electricity and dust build-
up, wipe outer surface of cleaner and
attachments.
Check motor safety filter occasionally and
DO NOT USE ATTACHMENTS IFTHEY ARE
WET.
! CAUTION ...................
Attachments used in dirty areas,
such as under a refrigerator, should
not be used on other surfaces until
they are washed,They could leave
marks.
i iiiii1,1111
change when dirty
Electrical Shock Hazard
Unplug power cord from electrical
outlet, Do not operate the cleaner
without the motor safety filter. Be
sure the filter is dry and properly
installed to prevent motor failure
and/or electrical shock,
Remove the bag as outlined in the BAG
CHANGING section.
MOTOR SAFETY FILTER
ELECTROSTATIC
This white and grey filter must be replaced
when dirty, It should be replaced regularly
depending on use conditions° The filter
CANNOT be washed as it will lose its
dust trapping ability.
1. Lift the rubber
retainer and pull
out motor safety
filter as shown.
Rubber
Retainer
WYd///
2. Reptace the fil-
ter, white side out,
by sliding it back
into place under
the ribs in the bag
cavity. Tuck filter in
so that it fits com-
pletely under the
rubber retainer
3, Replace the bag as outlined in the BAG
CHANGING section.
13
Loading ...
Loading ...
Loading ...