Loading ...
Loading ...
Loading ...
18
MAINTENANCE & TROUBLESHOOTING
MAINTENANCE
Cleaning
The bike can be cleaned with a soft, clean damp cloth. Do not use abrasives or solvents on the
plastic parts. Wipe your perspiration off the bike after each use. Be careful not to get excessive
moisture on the computer display panel as this might cause an electrical hazard or the electronics
to fail. Keep the computer console and the bike, out of direct sunlight to prevent screen damage.
Inspect all assembly bolts, nuts, screws, and pedals on the machine for proper tightness every
week.
Storage
Store the bike in a clean and dry environment away from pets and children.
TROUBLE SHOOTING
PROBLEM: There is no display on the computer console.
SOLUTION: Remove the Console Cover (69) and verify that the wire that comes from the
computer console is properly connected to the wires that come from the rear frame.
SOLUTION: Check if the batteries are correctly positioned and the battery springs are in proper
contact with the batteries.
SOLUTION: The batteries in the computer console may be dead. Replace the dead batteries with
new batteries.
PROBLEM: There is no heart rate reading or the heart rate reading is erratic / inconsistent.
SOLUTION: Make sure that the wire connections for the hand pulse sensors are secure.
SOLUTION: To ensure the pulse readout is accurate, always hold on to the handlebar grip sensors
with two hands instead of just with one hand.
SOLUTION: Avoid gripping the hand pulse sensors too tight. Try to maintain even pressure while
holding onto the hand pulse sensors.
PROBLEM: The bike makes a squeaking noise when in use.
SOLUTION: The bolts may be loose on the equipment. I all of the nuts, bolts, screws and tighten
any loose Hardware.
Loading ...
Loading ...
Loading ...