Loading ...
Loading ...
Loading ...
8
Installation Requirements
Installation Requirements
Venting Methods
Smoke is exhausted to the outside through a special pipe connected to the hood.
(Recirculating)
Wall Venting
Roof Venting
B
A
A. Deflector
B. 6" (15.2 cm)
A. Wall cap
B. 6" (15.2 cm)
A. Roof cap
B. 6" (15.2 cm)
B
A
B
A
Roof Venting Wall Venting (Recirculating)
A. Roof cap
B. 6" (15.2 cm)
A. Wall cap
B. 6" (15.2 cm)
A. Deflector
B. 6" (15.2 cm)
CAUTION
• The minimum connectable exhaust outlet diameter is 6 " (15.2 cm).
• Ensure the exhaust outlet diameter and duct diameter match, and then connect
the duct to the wall outlet.
• If the duct and the wall outlet have different diameters, the suction performance
will decrease while also significantly increasing noise.
The manufacturer is not responsible for any problems caused by this.
• Use the minimum possible length for the duct, and do not significantly alter the
cross-section.
• When connecting the duct, minimize bending. (Max bending angle: 90˚)
• In an environment where installing with an external venting method is possible,
be sure to install only using the external venting method.
Parts List
User & Installation
manual (2)
Template for
Installation (1)
Hood Mounting
Bracket (1)
Duct Cover Mounting
Bracket (1)
Electric Damper (1)
NK3*CB700W** only
Damper (1)
NK3*CB600W** only
Damper Adapter (1) Upper Duct Cover (1) Lower Duct Cover (1)
5 mm Magnet (2) Filter Support Cable * (2)
* To reduce the risk of the filter dropping, assemble the filter support cable to the
filter.
Loading ...
Loading ...
Loading ...