AEG HRE95770FB

User Manual - Page 17

For HRE95770FB.

PDF File Manual, 20 pages, Read Online | Download pdf file

HRE95770FB photo
Loading ...
Loading ...
Loading ...
Problem Possible cause Remedy
The fuse is blown. Make sure that the fuse is the cause of
the malfunction. If the fuse is blown
again and again, contact a qualified
electrician.
You do not set the heat setting for
60 seconds.
Activate the hob again and set the
heat setting in less than 60 seconds.
You touched 2 or more sensor fields
at the same time.
Touch only one sensor field.
Pause operates. Refer to "Daily use".
There is water or fat stains on the
control panel.
Clean the control panel.
You can hear a constant beep
noise.
The electrical connection is incor‐
rect.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
You cannot select the maximum
heat setting for one of the cook‐
ing zones.
The other zones consume the maxi‐
mum available power.
Your hob works properly.
Reduce the heat setting of the other
cooking zones connected to the same
phase. Refer to "Power management".
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds when
the hob is deactivated.
You put something on one or more
sensor fields.
Remove the object from the sensor
fields.
The hob deactivates. You put something on the sensor
field .
Remove the object from the sensor
field.
Residual heat indicator does not
come on.
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor is damaged.
If the zone operated sufficiently long to
be hot, speak to an Authorised Service
Centre.
You use a very tall pot which blocks
the signal.
Use a smaller pot, change the cooking
zone or operate the hood manually.
PowerBoost does not operate. The highest heat setting is set. The highest heat setting has the same
power as the function.
You decreased the heat setting to 0. Start from 0 and increase the heat set‐
ting.
You cannot activate the outer
ring.
The cooking zone was not activated. Set a heat setting for the cooking zone
first.
There is a dark area on
the multiple zone.
It is normal that there is a dark area
on the multiple zone.
The control panel becomes hot to
the touch.
The cookware is too large or you put
it too close to the control panel.
Put large cookware on the rear zones,
if possible.
There is no sound when you
touch the panel sensor fields.
The sounds are deactivated. Activate the sounds. Refer to "Daily
use".
The indicator above the symbol
comes on.
Child Safety Device or Lock oper‐
ates.
Refer to "Daily use".
ENGLISH 17
Loading ...
Loading ...
Loading ...