Loading ...
Loading ...
Loading ...
13 HOMEDEPOT.COM
Please contact 1-855-847-7264 for further assistance.
Operation (continued)
Power
indicator light
Timer indicator
light(only set by
remote controller)
Either Timer
or Wireless
indicator light
LED display
Shows the set temperature while on cool, heat or auto mode. While on DRY and FAN modes, it shows the room
temperature.
Shows Error codes:
□ E0-EEPROM error.
□ E1-Room temperature sensor error.
□ E2-Evaporator temperature sensor error.
□ E3-Condenser temperature sensor error (on some models).
□ E4-Display panel communication error.
□ EC-Refrigerant leakage detection malfunction (on some models).
Shows protection code:
□ P1-Bottom tray is full--Connect the drain hose and drain the collected water away.
If protection repeats,call for service.
NOTE: When one of the above malfunctions occurs, turn off the unit, and check for any obstructions. Restart the unit,
if the malfunction is still present, turn off the unit and unplug the power cord. Contact the manufacturer or its service
agents or a similar qualied person for service.
Power button
Power switch on/off
2
Constant Fan operation(On some models)
□ In Cooling or Dry mode, press the MODE button for 3 seconds to turn on or off the constant fan function. When the function is turned
on, the constant fan light will illuminate, identifying that the fan runs continuously for cooling. When this function is turned off, the
constant fan light will go out, identifying the running fan cycle and compressor is stopped.
3
I SENSE feature
□ This feature can be activated from the remote control ONLY. The remote control serves as a remote thermostat allowing for the precise
temperature control at its location. To activate the I SENSE feature, point the remote control towards the unit and press the I SENSE
button. The remote control will send this signal to the air conditioner until the I SENSE button is pressed again. If the unit does not
receive the I SENSE signal during any 7 minutes interval, the unit will exit the I SENSE mode.
NOTE: This feature is unavailable in FAN or DRY mode.
4
Auto-Restart
□ If the unit turns off unexpectedly due to the power cut, it will restart with the previous function setting automatically when the power
resumes.
□ WAIT 3 MINUTES BEFORE RESUMING OPERATION
□ After the unit has stopped, it can not be restarted in the rst 3 minutes. This is to protect the unit. Operation will automatically start
after 3 minutes.
Loading ...
Loading ...
Loading ...