Loading ...
Loading ...
Loading ...
chargepoint.com 11
Wire the Circuit
1. Install a plug-in or hardwired circuit:
• For a 40 or 50 amp plug-in installation, wire the circuit with the
appropriate 6-50 or 14-50 outlet. Install the outlet with the ground
facing up.
• For a hardwired installation, provide a listed conduit with wiring to the
bottom or rear 19 mm (3/4 in) knockout for AC input. Seal the unused
knockout with the plug provided. Return the original input power
cable to the box.
2. Affix the label with the appropriate rating to the circuit in the panel.
3. Turn off power to the circuit at the panel before proceeding.
Mount the Charging Station
Note: For Hardwired Installation, proceed to page 13.
Plug-In Installation
1. Remove the faceplate and the wire cover from the charging station. Set
them aside.
2. Mark the center of the stud with a line
approximately 1000-1100 mm (39-43 in) above the
finished floor.
DANGER: RISK OF SHOCK. Turn off the circuit breaker to the 240 V
outlet. Do not restore power to the outlet until installation is
complete. Failure to follow these instructions could result in shock
or electrocution.
Loading ...
Loading ...
Loading ...