GBSC3HBYARCC User Manual

Loading ...

Performance Data Sheet

SmartWater Filtration System

MWF Cartridge

This system has been tested according to NSF/ANSI 42/53 for reduction of the substances listed below.

The concentration of the indicated substances in water entering the system was reduced to a concentration

less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42/55.*

200% safety factors built in for unmetered usage)

Standard No. 42: Aesthetic Effects

Parameter USEPA Influent

MCL Challenge Concentration

Chlorine - 2.0mg/L+ 10%

T&O - -

Particulate** - _>10,000particles/mL

Influent

Average

1,96 mg/L

6,400,000#/mL

Effluent

Average Maximum

0.06mg/L 0.11mg/L

58,833#/mL 150,000#/mL

% Reduction

Average Minimum

96.77% 94.74%

99.14% 97.97%

Parameter

Turbidity

Cysts

Asbestos

Leadat pH65

Leadat pH8.5

Nercurgat pH6.5

Nercurgat pH8.5

Alachlor

Lindane

2,4-D

Toxaphene

Benzene

Carbofuran

1,4dichlorobenzene

USEPA

MCL

05 NTU

_>99.95%Reduction

_>99%Reduction

0,015mg/L

0.015mg/L

0.002mg/L

0.0002mg/L

0.070mg/L

0.003mg/L

0.005mg/L

0.040mg/L

0.075mg/L

Standard No. 53: Health Effects

Influent

Challenge Concentration

11+ 1 NTU***

Ninimum50,000L

107to 108fibers/L;> 10pm

0.15mg/L+ 10%

0.006mg/L+ 10%

0.04mg/L+ 10%

0.002mg/L+ 10%

0.210mg/L+ 10%

0.015mg/L+ 10%

0.080mg/L+ 10%

0.225mg/L+ 10%

Influent

Average

10.5 NTU

118,750 #/L

57 MF/L

0.1567 mg/L

0.1433 mg/L

0.0059 mg/L

0.0057 mg/L

0.0367 mg/L

0.0020 mg/L

0.2033 mg/L

0.0160 mg/L

0.0145 mg/L

0.0830 mg/L

0.2283 mg/L

Effluent

Average

0.14NTU

< I#/L

0.996MF/L

< 0.001mg/L

0.000350mg/L

0.000325mg!L

0.00023mg/L

<0.00002mg/L

0.00337mg/L

0.00100mg/L

0.000500mg/L

0.001000mg/L

0.000500mg/L

Maximum

0.28NTU

4#/L

< 1 MF/L

< 0,001mg/L

0.0007mg/L

0.0006mg/L

0.0004mg/L

<0.00002mg/L

0.011000mg/L

0.001000mg/L

0.000500mg/L

0.001000mg/L

0.000500mg/L

% Reduction

Average Minimum

98.54% 97.20%

> 99.99% > 99.99%

99.60% 99.39%

99.36% 99.29%

99.30% 99.29%

94.70% 87.50%

93.20% 89.29%

99,34% 98.67%

99.00% 98.95%

98.32% 94.50%

93.44% 91.67%

9651% 95.83%

98.78% 98.65%

99.78% 99.77%

Atrazine 0.003mg/L 0.009 mg/L±10% 0.0087 mg/L < 0.0005 mg/L < 0.0005 mg/L 94.22% 93.33%

Tested using a flow rate of 0.50 gpm; pressure of 60 psig; pH of 7.5 +_0.5; temp. of 68 ° +_5°F (20° +_3°C)

** Measurement in Particles/ml. Particles used were 0.5-ff microns

*** NTU=Nephelometric Turbidity units

Min. Required

Reduction

> 50%

_>85%

Min. Required

Reduction

0.5NTU

_>99.95%

_>99%

0.010mg/L

0.002mg/L

0.0002mg/L

0.070mg/L

0.003mg/L

0.005mg/L

0.04mg/L

0.075mg/L

0.003mg/L

Operating Specifications

[] Capacity: certified for up to ]00 gallons (1115 I); up to six months for models without a replacement filter indicator light;

up to one year for models with a replacement filter indicator light

[] Pressure requirement: 40-120 psi (2.8-8.2 bar), non-shock

[] Temperature: ]]-IO0°F (0.6-]8°C)

[] Flow rate: 0.5 gpm (1.9 Ipm)

General Installation/Operation/Maintenance Requirements

[] Flush new cartridge at full flow for ] minutes to purge out trapped air.

[] Replace cartridge when the indicator light flashes or water flow rate is reduced on non-indicator units.

Special Notices

[] Installation instructions, parts and service availability, and standard warranty are included with the product when shipped.

[] This drinking water system must be maintained according to manufacturer's instructions, including replacement of filter cartridges.

[] Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or

after the system. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts.

[] The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.

[] Check for compliance with the state and local laws and regulations.

[] Note that while the testing was performed under standard laboratory conditions, actual performance may vary. Systems must be

installed and operated in accordance with manufacturer's recommended procedures and guidelines.

Standard No. 42: Aesthetic Effects

Chemical Unit

Chlorine Taste and Odor

Mechanical Filtration Unit

Particulate Reduction, Class I

System Tested and Certified by NSF International against ANSI/NSF Standard 42 & 53 for the reduction of:

Standard No. 53: Health Effects

Chemical Reduction Unit

Alachlor and Atrazine Reduction

Benzene and Carbofuran Reduction

1,4 dichlorobenzene and 2,4-D Reduction

Lead and Lindane Reduction

Mercury and Toxaphene Reduction

Mechanical Filtration Unit

Turbidity Reduction

Cyst and Asbestos Reduction

Manufactured for: General Electric Company, Louisville, KY 40225

EPA EST.No. 070595-MN-001

Loading ...

User Manual - Page 41