Loading ...
Loading ...
Loading ...
USB High-Definition Live Camera User Manual
14
8) NTP Settings
Turn On/Off NTP time sync, Main time show and
Sub time show; select the Time Zone; set up the
Server address, Time interval and the Time Show
Position of the two streams.
6.8 Device Information
The above information is for reference only,
please refer to the real product for the actual
specification.
6.9 Download the Upgrade Program
If you need the camera upgrade program, please
contact the manufacturer.
WEB interface and parameters are
subject to change without notice.
7 Troubleshooting
Image
The monitor shows no image
1) Check that the camera power supply is
connected, the voltage is normal, and the
power indicator is always on.
2) Turn off the power switch to check whether
the camera is self-testing.
3) Check the cable of video platform and TV
whether in correct connection.
Image jitters after the camera is properly
connected
1) Check whether the camera installation is
stable.
2) Check whether any vibrating machinery or
object near the camera.
There is no video image in Browser
IE browser does not support H5, you need to use
VLC plug-in to view videos. Please visit VLC
website (http://www.videolan.org/vlc)
to download and install the 32-bit VLC media
player, after installation, the video image will be
displayed normally when visit the camera. Other
mainstream browsers already support H5 and do
not need to install the VLC plug-in.
Unable to access camera through Browser
1) Using PC to access the network to test that
the network access can work properly to
eliminate the network fault caused by cable
and PC virus until the PC and camera can
ping each other.
2) Disconnect the network, connect camera
with PC separately and reset the IP address
of PC if necessary.
3) Check that the IP address, subnet mask and
gateway settings for camera is correct.
4) Check that the MAC address is conflicts.
5) Check that the web port is modified, the
default setting is 80.
Forget the IP address or login password
The default IP address is: 192.168.100.88; the
default username and password are both: admin.
Control
Remote control does not work
1) Check and replace with new batteries.
2) Check whether the camera is in normal
working mode.
3) Check whether the address key of remote
control can match the camera.
Serial port cannot control
1) Check whether the protocol, address and
baud rate of camera are consistent.
2) Check whether the control line is properly
connected.
Information
HD Camera
Device ID
I3.V
Device Type
v1.5.5
Webware Version
SOC v9.8.88 -ARM v7.3.27S
Software Version
Submit Cancel
Loading ...
Loading ...
Loading ...