Loading ...
Loading ...
Loading ...
7
INITIAL INSTALLATION INSTRUCTIONS
4. Loosen the two coupling screws(P) preassembled in
coupling (Q), but do not remove them.
Remove the hairpin clip (O) and clevis pin (N) from the
downrod assembly (B). Retain for later use.
Note: Make sure to keep loose hardware separate to
avoid confusion during installation.
STANDARD/ANGLE-MOUNTING INSTRUCTIONS
1. Place downrod assembly (B) through canopy (C),
canopy cover (D) and coupling cover (E).
C
D
E
B
Q
1
Feed power wires from motor housing (F) through
downrod assembly (B), then insert downrod assembly
(B) into the coupling (Q) on motor housing (F).
2.
Align the hole on downrod assembly (B) to hole on
coupling (Q), then re-install clevis pin (N). Re-attach
hairpin clip (O) into clevis pin (N) until it snaps into
place, then tighten the two previously loosened
coupling screws (P).
O
P
B
Q
N
2
F
P
B
N
O
4
Loading ...
Loading ...
Loading ...