Loading ...
Loading ...
Loading ...
HEAT CONTROLS
Check that the Power Switch on the side of the heater is set to the Off position before plugging
the heater in and turning on the mains supply. Turn the Power Switch at the side of the heater
to the 'I' position. You will hear a beep.
CONTROL PANEL
Press the On/Off button '20' to switch the appliance on. The display lights up.
The appliance is now ready for use and can be operated by means of the remote control or
control panel
HEAT SETTINGS
• The appliance has three heat settings: 900 watts, 1,300 watts & 2,200 watts
• Press button '21' repeatedly until the desired heat setting is set.
• Selected heating level is shown in the display.
THERMOSTAT
• Selected your desired temperature by pressing either button '16' to increase temperature up
to 32 °C or button '17' to decrease temperature down to 16 °C.
• The selected temperature will be displayed on the control panel. measurement 14 is shown
in the display 5.
• After a few seconds the display will change back to showing the current room temperature
but the set temperature will be stored and the heater will continue to run until that
temperature is reached.
Temperature is measured directly at the appliance using temperature sensor '8'. It may be some
time before the entire room has also reached this temperature.
TIMER
• The appliance has a timer for setting the heating time to between 0.5 and 24 hours. The
appliance switches off automatically once the heating time has expired.
• Press timer button '18' repeatedly until desired running time is shown in display 5.
• To switch off the timer, press timer button '18' repeatedly until running time is no longer
displayed.
11. Selected heating level display
12. Infrared reception
13. 'Frost protection' symbol
14. Set temperature display
15. On/Off display
16. Increase temperature
17. Reduce temperature
18. Timer button
19. Running time display
20. On/Off button
21. Button for selecting the heat
setting
Operating Your Heater
Loading ...
Loading ...
Loading ...