Loading ...
Loading ...
Loading ...
Components
ASSEMBLY
Before using the heater, the feet (supplied separately in the carton), must be fitted
to the unit. The screw pack to attach the feet to your heater will be taped to either
one of the feet for your heater or taped to the plug.
Carefully turn the Main Body upside-down on a scratch-free and stable surface. Be
careful to prevent damage to the cosmetic finish or your floor surfacing.
Before the appliance can be used, the feet must be screwed on as follows:
1. Unpack the appliance from the packaging.
2. Remove the transport packaging.
3. Check that the appliance shows no signs of damage.
4. Slide the feet from the outside into the corresponding supports on the underside
of the heater.
5. Secure the feet firmly using the screws supplied.
WARNING: Operate the heater in the normal upright position only with
the feet attached to the bottom. Any other position could create a hazardous
situation.
1 Power cord
2 Control panel
4 Air outlet
5 Display
6 Air inlet
7 Feet
8 Temperature sensor
9 Mains switch
10 Handle
WARNING: Heater must not be used without the feet fitted.
This appliance has been supplied with ‘1 way screws’ for permanent installation of the
feet. This is a safety requirement for the New Zealand and Australian market.
Loading ...
Loading ...
Loading ...