Loading ...
Loading ...
Loading ...
10 ENGLISH
Changing the impact force
You can change the impact force in four steps: 4 (max), 3 (hard), 2 (medium), and 1 (soft).
This allows a tightening suitable to the work.
The level of impact force changes every time you press the button
or the quick mode-switching button.
You can change the impact force within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the impact force approximately one minute if you press the but-
ton
, , or the quick mode-switching button.
1
► 1. Button
Application mode
(Impact force grade
displayed on panel)
Maximum blows Purpose Example of application
4 (Max)
3,800 min
-1
(/min) Tightening with the maximum force
and speed.
Driving screws to underwork materi-
als, tightening long screws or bolts.
3 (Hard)
3,600 min
-1
(/min) Tightening with less force and speed
than Max mode (easier to control than
Max mode).
Driving screws to underwork materi-
als, tightening bolts.
2 (Medium)
2,600 min
-1
(/min) Tightening when a good nishing is
needed.
Driving screws to nishing boards or
plaster boards.
1 (Soft)
1,100 min
-1
(/min) Tightening with less force to avoid
screw thread breakage.
Tightening sash screws or small
screws such as M6.
: The lamp is on.
NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
or the
quick mode-switching button.
NOTE: All lamps on the switch panel go out when the tool is turned o to save the battery power. The impact force
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
Loading ...
Loading ...
Loading ...