Loading ...
Loading ...
Loading ...
15
Parameter Description
Tilt Detector
Config
You can enable or disable the tilt detector. After enabling, you can configure
tilt detector parameters.
●
Link Tilt Alarm to Siren
●
Tilted Angle: You can select from
5deg
,
10deg
,
15deg
,
20deg
,
25deg
.
The default value is
5deg
. When the detector detects the tilted angel
exceeds the set value, an alarm is triggered.
●
Delay Tilt Alarm: You can select from
1s
,
2s
,
3s
,
5s
,
10s
,
15s
,
20s
,
30s
,
45s
,
60s
. The default value is
2s
. When the detector detects that the
tilted angle exceeds the set angle and does not recover beyond the set
time, an alarm is triggered.
Chime
After enabling, when the area is disarmed, if the door detector is opened, the
indoor siren will be triggered.
Over-
temperature
Alarm
Enable the
Over-temperature Alarm
function, and then the alarm will be
triggered when the temperature of the area where the water leak detector is
installed is higher or lower than the defined one.
Signal Strength
Detection
Test the current signal strength.
Detector Test Detect whether the peripheral works.
Transmit Power
●
Select from high, low, and automatic.
●
The higher the transmission power, the farther the signal can travel, but
the greater the power consumption.
●
If you select
Low
, the door detector plus will enter reduced sensitivity
mode until you select another option.
●
The reduced sensitivity mode is only available when the version of the
DMSS app is 1.97 or later, the hub is V1.001.0000000.6.R.211228 or later,
and the door detector is V1.000.0000001.0.R.20211203 or later.
Cloud Update Update online.
Delete
Delete the online peripheral.
Go to the hub screen, select the peripheral from the list, and then swipe left
to delete it.
Loading ...
Loading ...
Loading ...