Loading ...
Loading ...
Loading ...
English
12
Fig. J
6
14
Unloading The Tool (Fig. J)
WARNING: The trigger lock-off should always be
locked off whenever any adjustments are made or
when tool is not inuse.
1. Press magazine latch
14
and open sliding magazine
6
fully.
2. Tip the tool up until the staples slide freely out of the
bottom of the magazine.
3. Check to ensure no loose staples remain inside
magazine.
4. Close sliding magazine fully
Dryfire Lock Out Feature (Fig. A)
Tool is equipped with a dryfire lock out feature to prevent
tool from cycling when there are no fasteners loaded. When
no fasteners are visible in the fastener window
15
, the tool
is running low on fasteners. If this happens, the tool will
be locked out and will not actuate until more staples are
loaded. (Refer to Loading the Tool)
Adjusting Depth (Fig. K)
The depth that the fastener is driven can be adjusted using
the depth adjustment wheel
3
on the side of thetool.
WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust
depth, ALWAYS:
• Remove batterypack.
• Engage trigger lock-off.
• Avoid contact with trigger duringadjustments.
1. To drive the staple shallower
, rotate the depth
adjustment wheel
3
away from the nose of thestapler.
2. To sink a staple deeper
, rotate the depth
adjustment wheel
3
toward the nose of thestapler.
Fig. K
3
11
Headlights (Fig. L)
There is a headlight
4
located on each side of the stapler.
Headlights turn on upon battery insertion, activation of
the trigger, or depressing the contact trip. The lights will
automatically shut off after 20 seconds unless tool remains
inuse.
Fig. L
4
nOTE: These headlights are for lighting the immediate work
surface and are not intended to be used asflashlights.
lOW BATTERY inDiCATOR: The left-side headlight will
flash four consecutive times and then shut down to indicate
lowbattery.
JAMMED sTAPlE inDiCATOR: The right-side headlight
will flash continually if a staple becomes jammed in the
nosepiece (see Clearing a Jammed Staple).
Clearing a Jammed Staple (Fig. A, M)
If a staple becomes jammed in the nosepiece, keep the
tool pointed away from you and follow these instructions
toclear:
1. Remove battery pack from tool and engage the trigger
lock-off.
2. Press the magazine latch
14
and remove any loaded
staples.
3. Visually check inside magazine for any jammed staples.
4. Remove bent staple, using pliers if necessary.
5. If driver blade is in the down position, cycle the stall
release lever
10
using enough force to fully slide it to
the other end of the slot in the housings.
6. Reinsert staples into magazine (see Loading the Tool)
7. Reinsert battery pack.
nOTE: The tool will disable itself and not reset until the
battery pack has been removed and reinserted.
Loading ...
Loading ...
Loading ...