Loading ...
Loading ...
Loading ...
TP-7092 2/21 19Section 1 Descriptions and Service Views
1.8.6 Carburetor Heater
An optional carburetor heater is recommended for
improved cold starting in locations where the ambient
temperature drops below 0C (32F). The carburetor
heater prevents condensation and carburetor icing. The
heater requires a continuous source of AC power.
See the generator set Installation manual for more
information.
Voltage 120 VAC 240 VAC
Thermostat ON
4 ± 3C (40 ± 5F)
Thermostat OFF
16 ± 3C (60 ± 5F)
Figure 8 Heater Specifications, 14kW Models
Voltage 120 VAC 240 VAC
Thermostat ON
4 ± 4C (40 ± 7F)
Thermostat OFF
16 ± 3C (60 ± 5F)
Figure 9 Heater Specifications, 20kW Models
2
GM19463
1. 120 VAC plug
2. Thermostat
3. 240 VAC 3-pin Mate-N-Lock connector.
1
3
Figure 10 Carburetor Heater with Thermostat and Power Connectors, 14kW Models
1
GM57968
1. Heating element
2. 1/8 NPT threaded fitting
3. Power cord disconnect plug
4. Thermostat
5. 120 VAC plug
6. 240 volt 3-pin plug
3 4 52
GM88228
6
Figure 11 Carburetor Heater, 20kW Models
1.8.7 Emergency Stop Kit
An emergency stop button is available as a loose kit.
Pressing the emergency stop button causes the
generator set to shut down immediately. The generator
controller displays an emergency stop shutdown
message after the button is pressed.
E-stop assembly harness contains the E-stop, contact
block, and two leads connected to the contact block.
The harness is factory-assembled. The kit also includes
the emergency stop switch decal.
The generator set enclosure is designed with an
opening for the emergency stop button. Install the
emergency stop button as described in the TT- 1613
and TT- 1795 instructions.
RDC2 firmware to version 5.5 or higher is required for
E-stop operation. Use a personal computer (laptop) and
Kohler SiteTech software or the USB Utility to update
the controller firmware, if necessary. See TP-6701,
SiteTech Operation Manual, or TT-1636, Firmware
Update Using the USB Utility, for instructions if
necessary.
Loading ...
Loading ...
Loading ...