Loading ...
Loading ...
Loading ...
9
ENGLISH
FRONT PANEL FUNCTIONS
[21] PRO DSP FX
F 12XR is equipped with an internal 16 preset PRO DSP FX board. Rotating the encoder allows selection
between 16 great sounding effects:
ROTATE
[22] PFL ACTIVE LED
This LED lights up when one or more PFL buttons are pressed.
[24] FX TO AUX
This send allow routing the signal present in the FX return channel to the AUX1 sends.
[25] AUX1 AND AUX2/FX MASTER KNOBS
These potentiometers control the master level of the auxiliary sends AUX1 and AUX2/FX. The PFL
button when pressed allows listening the signal present in the aux out, through speakers connected
to the CTRL ROOM OUTPUT (see section [11] of this manual) or through headphones connected to
PHONES OUTPUT (see section [7]).
[26] CTRL ROOM LEVEL KNOB
This is the level control of the signal routed to CTRL ROOM OUTPUT. During the mixer’s normal use,
the MAIN MIX signal is routed to this output; when one or more PFL buttons are pressed the PFL bus
signal is routed to CTRL ROOM OUTPUT and PHONES OUTPUT.
[27] AUX2 PRE/POST BUTTON
This button allows selection of the AUX2/FX position, pre-fader or post-fader. See section [23] of this
manual.
[28] PHONES LEVEL
This knob controls the level of the PHONES OUTPUT [7]. Set the PHONES LEVEL control to minimum
(-∞) before connect and wear headphones to avoid hearing loss.
[29] PAN
These controls allow positioning of the signal present in the mono channel in the stereo image of the
MAIN MIX.
[30] PAN/BAL
The control works as PAN if the channel is used in MONO configuration (XLR MIC INPUT) defining the
position of the signal into the stereo image of the MAIN MIX. BAL (Balance) control allows balancing of
the position of the stereo channel (TRS jack line stereo input) into the stereo image of the MAIN MIX.
[31] BAL
These controls, characteristic of stereo channels, allow balancing of the position of a stereo channel
into the stereo image of the MAIN MIX.
[23] AUX1- AUX2/FX
Each channel of the F 12XR mixer is provided with 2 auxiliary sends; AUX1 is
a PRE fader send. AUX2/FX send feed the internal PRO DSP FX board. AUX2/
FX is a POST or PRE fader send depending on the position of the AUX2 PRE/
POST button ([27]). When the selection is pre-fader AUX2/FX takes the signal
from the channel independently from the fader position; when the selection is
post-fader the AUX2/FX takes the signal subjected to the fader position. The
signal present in the AUX2/FX send is also routed to the AUX OUTPUT jack
present on the top panel (see section [5] of this manual).
01. SMALL HALL
02. LARGE HALL
03. SMALL ROOM
04. BRIGHT ROOM
05. THIN PLATE
06. PLATE
07. SPRING REVERB
08. MULTITAP DELAY
09. ANALOG DELAY
10. CHORUS VERB
11. STEREO CHORUS
12. FLANGER
13. PHASER
14. GATED REVERB
15. FLANGER REVERB
16. VOCAL ECHO
Select one of these effect presets to enrich your sound.
Loading ...
Loading ...
Loading ...