Loading ...
Loading ...
Loading ...
- 7 -
level surface. Ensure at least 15cm of space between the back and sides of the
appliance and the wall. Don’t place anything on the appliance.
3. The appliance must be positioned where the plug is accessible.
4. The button “ON”: Put small ice cubes into the hopper, cover it, plug in the
power cord, then poke the switch to ON. It will start to work and crush ice into small
granules.
NOTE:The machine must stop working for 10min once 30min, or it will make the
motor overheat and stop working.
5. The button “OFF”: Press the power switch to OFF, and the machine will stop
working.
6. The button “Reverse”: Use for a few seconds if hopper is jammed with ice and
no crushed ice come out, then switch Reverse for a while, then back to ON to
resume crushing ice.
7. The button “Rough/Fine”: Adjust the knob to control the size of ice particles.
NOTE:
If the ice cubes are compacted and don’t move during working time, switch
Reverse for a while, then back to ON to resume crushing ice.
The crushed ice inside the catch container can't be very full of touching the outlet,
or it will get lodged in the chopped blade.
This machine can only be used to shave ice. This machine is suitable for
shaving small ice cubes with a side length of no more than 2-3CM. Large ice
cubes may cause the machine to jam or even burn out the motor.
WARNING:
The blade is very SHARP and operates with care.
Don’t pour water directly into the hopper and the feed to clean, which will cause an
electrical short circuit and increase the risk of a short circuit or electric shock.
Unplug the ice shaver before cleaning.
The use of any appliance must follow basic guidelines, in particular:
A high-humidity environment will increase the risk of short circuits or electric shock.
If in doubt, cut off the power of the ice shaver.
Turn off the machine by the switch, then pull the plug from the outlet.
Loading ...
Loading ...
Loading ...