Loading ...
Loading ...
Loading ...
12
bromic.com/heating-au
ELECTRICAL INSTALLATION
!
WARNING
This heater MUST be permanently installed by an
authorised/licenced person. Do not perform
maintenance, or carry out installation or assembly
procedure while electrical power is switched on.
1. Check product label for correct voltage and wattage to
ensure sure power source conforms to the heaters
requirements.
2. Use appropriate power supply cables for the heaters’
voltage and wattage. The fixed wiring must be
positioned away from & protected from the enclosure of
the heater.
3. Make all connections in accordance with local electrical
code regulations. For outdoor installation, all
connections must be made in accordance with local
electrical code regulations for outdoor wiring. Only use
wiring components approved for outdoor use with
minimum IPX4 rating.
WARNING
ELECTRICAL SHOCK HAZARD! Serious injury or death
may occur. Disconnect from electrical supply before
installing or servicing this heater. Read and follow
installation clearance requirements outlined in this
manual. The appliance MUST be connected to a properly
grounded electrical source.
!
ELECTRICAL INSTALLATION
WARNING
ELECTRICAL SHOCK HAZARD!
Serious injury or death may occur. Disconnect from
electrical supply before servicing this heater.
!
For longest product life, and to maintain product
appearance, mount heater under cover and protect from
rain and weather whenever possible.
The exterior housing of the heater should be cleaned
regularly. To clean the appliance; ensure heater is off, and
has been off for at least 2 hours after operation, before
wiping off any dirt/dust with a soft damp cloth.
Salt in the air can cause rusting of metal, especially at
locations near the coast. Additional cleaning of the heater
with a soft damp cloth fortnightly will aid in maintaining the
product’s appearance.
MAINTENANCE
SERVICING
WARNING
Servicing and maitenance MUST be carried out by an
authorised and licenced service person only.
!
WARNING
If the supply cord is damaged, it must be replaced
by Bromic, a service agent of Bromic or similarly
qualified persons in order to avoid a hazard. Contact
Bromic for further information on replacement of the
supply cord.
!
SYMPTOM POSSIBLE CAUSE (S) CORRECTIVE ACTION
No heat 1. Improper connection 1. Check connection to power supply
Not enough heat 1. Heater too small for application
2. Heater mounted too high or too
far
1. Add additional heater(s)
2. Decrease mounting height or
distance
Too much heat 1. Heater too large for application
2. Heater mount too low or too close
1. Replace with smaller heater
2. Increase mounting height or
distance
TROUBLESHOOTING
For wiring instructions using Bromic Platinum Smart-Heat Electric Wireless Dimmer 2620276-1 or ON/OFF Control
2620275-1 refer to instructions provided with controller.
IMPORTANT: Electronic dimmer controls generate heat during operation. For Bromic heaters installed Bromic Smart-
Heat Electric Wireless Dimmer 2620276-1 or ON/OFF Control 2620275-1 it is essential to ensure dimmers are mounted
in a clean, dry and well ventilated position with clearance on all sides. It must be ensured the dimmers are not
installed in a confined space, close to other heat generating appliances or in the case of a multi-dimmer installation,
not too close together. Dimmers must remain cool at all times. Please consult Bromic dimmer installation instructions
for further details or for further questions please contact Bromic technical support services.