Loading ...
Loading ...
Loading ...
6 49-5000491 Rev. 3
Manual Operation (POWER Button) and Maintenance
Manual Operation
• Use the POWER button only when the remote control is
lost or damaged.
• Press the POWER button and the unit will beep once,
indicating start of operation.
• The unit will run automatically in the following modes:
• While in Manual Operation, temperature and fan speed
cannot be changed, nor will it operate in timer or DRY
mode.
Inserting the Batteries
1. Remove the battery cover
2. Insert 2 AAA batteries as illustrated noting battery
polarity
3. Reinstall the battery cover
NOTE:
• The distance from the remote control to the receiver
should be less than 23 feet with no obstructions.
• If the remote control display is weak or the operating
distance has diminished, the batteries may need to be
replaced.
• Remote control malfunctions can sometimes be
corrected by removing the batteries from the remote for
a few minutes and then reinstalling them.
• Remove the batteries from the remote control if the
unit will not be in use for an extended period of time. If
any segments of the display remain active after battery
removal, press the reset button.
Optimizing Performance
1. Close doors and windows during operation
2. Do not block the air inlet or outlet
3. Wipe the cabinet using a soft and dry cloth. For serious
stains, use a neutral detergent diluted with water. Wring
the water out of the cloth before wiping down the unit.
Then wipe off the detergent completely.
Cleaning the Front Cover
1. Open the front cover by pulling it upward
2. Remove the Filter:
Gently push up on the filter's center tab until it is
released from the stopper, and remove the filter in a
downward motion.
3. Clean the filter
Use a vacuum cleaner to remove dust, or wash the
filter with water. After washing, dry the filter completely.
4. Attach the filter
Attach the filter so that the "FRONT" label is facing
outward. Make sure that the filter is securely attached
behind the holding tabs. If the filter is not attached
correctly the unit may not achieve maximum efficiency.
5. Close the front cover.
EMERGENCY MAINTENANCE
Beep
emergency
operation switch
Room
Temperature
Designated
Temperature
Timer
Mode
Fan
Speed
Operation
Mode
Above 73°F 79°F No AUTO COOL
Below 73°F 73°F No AUTO HEAT
16. AUTO
The heat pump will automatically select Cool, Heat, or
Fan operation according to set temperature. When FAN
is set to AUTO the heat pump automatically adjusts the
fan speed according to room temperature.
17. VACATION
10°C/50°F Heating sets the system to maintain
10°C/50°F. This is used to prevent freezing during long
unoccupied periods of time.
18. TIMER ON/OFF
To set the Timer using the TIMER ON button, press
the CLOCK UP/DOWN. The time will be changed by 1
minute. Press the APPLY to confirm the setting. Press
the TIME OFF button to cancel the timer function.
19. CLOCK
To set the clock using the CLOCK button, press the
CLOCK UP/DOWN. The time will change by 1 minute.
Press the APPLY to confirm the setting. The clock will
keep the original time if the APPLY button is not pressed
in 10 seconds.
20. APPLY
Save and Cancel the TIMER and CLOCK selection.
21. F/C
Press F/C to switch the remote and unit display
temperature between Fahrenheit and Celsius.
Remote Control Features and Settings
Loading ...
Loading ...
Loading ...