Loading ...
Loading ...
Loading ...
10
To remove spur center (Figure 6):
Hold spur center to prevent it falling. (Use a rag to
protect your hand from the sharp edges). Insert
knockout rod through spindle hole and tap out spur
center.
Figure 6
7.5 Installing/removing live center
Refer to Figure 7.
The live center rotates with the workpiece and is
installed in the tailstock.
1. Rotate tailstock handwheel clockwise a few
times to advance quill.
2. Push live center into quill.
To remove live center:
3. Hold on to live center to prevent it from falling.
4. Rotate handwheel counterclockwise to retract
quill, until center releases from quill.
Figure 7
8.0 Electrical connections
The JWL-1015/JWL-1015VS JET lathe is rated for
115 volt operation. It is supplied with a plug
designed for use on a circuit with a grounded outlet
that looks like the one pictured in A, Figure 8.
Before connecting to power source, be sure switch
is in off position.
It is recommended that the lathe be connected to a
dedicated 10 amp circuit with a circuit breaker or
time-delay fuse. Local codes take precedence
over recommendations.
8.1 Grounding instructions
1. All Grounded, Cord-connected Tools:
In the event of a malfunction or breakdown,
grounding provides a path of least resistance for
electric current to reduce the risk of electric shock.
This tool is equipped with an electric cord having
an equipment-grounding conductor and a
grounding plug. The plug must be plugged into a
matching outlet that is properly installed and
grounded in accordance with all local codes and
ordinances.
Do not modify the plug provided - if it will not fit the
outlet, have the proper outlet installed by a
qualified electrician.
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. The
conductor with insulation having an outer surface
that is green with or without yellow stripes is the
equipment-grounding conductor. If repair or
replacement of the electric cord or plug is
necessary, do not connect the equipment-
grounding conductor to a live terminal.
Check with a qualified
electrician or service personnel if the
grounding instructions are not completely
understood, or if in doubt as to whether the
tool is properly grounded. Failure to comply
may cause serious or fatal injury.
Use only 3-wire extension cords that have 3-prong
grounding plugs and 3-pole receptacles that accept
the tool's plug.
Repair or replace damaged or worn cord
immediately.
2. Grounded, cord-connected tools intended for
use on a supply circuit having a nominal rating less
than 150 volts:
This tool is intended for use on a circuit that has an
outlet that looks like the one illustrated in A, Figure
8. An adapter, shown in B and C, may be used to
connect this plug to a 2-pole receptacle as shown
in B if a properly grounded outlet is not available.
The temporary adapter should be used only until a
properly grounded outlet can be installed by a
qualified electrician. This adapter is not permitted
in Canada. The green-colored rigid ear, lug, and
the like, extending from the adapter must be
connected to a permanent ground such as a
properly grounded outlet box.
Loading ...
Loading ...
Loading ...