Loading ...
Loading ...
Loading ...
8
3.3 Unpacking
To unpack the device, proceed as follows:
Remove the device out of the carton and remove the packaging material.
3.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-related
points of view and can therefore be recycled. Returning the packaging back to the material loop
saves raw materials and reduces the quantities of accumulated waste. Take any packaging
materials that are no longer required to “Green Dot” recycling collection points for disposal.
3.5 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must fulfil
the following prerequisites:
The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing
capacity for the HW 500 Touch.
Place the device only on a waterresistent surface.
Do not use the device outdoors.
Do not operate the product near hot gas or hot stove.
Choose the setup location in such a way that children cannot reach the device.
The device is not intended to be installed in a wall or a built-in cupboard.
Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
The electrical socket must be easily accessible so that the power lead can be disconnected
easily, in the case of an emergency.
The installation and assembly of this device in non-stationary setup locations (e.g. on ships)
must be carried out by specialist companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
3.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
Before connecting the device, compare the connection data (voltage and frequency) on the
rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.
The electrical outlet must be protected by a 16A safety cut-out switch.
The use of multiple plugs or gangs is prohibited because of the danger of fire that is involved
with this.
Make sure that the power cable is undamaged and has not been installed under the ice maker
or over hot or sharp surfaces.
The electrical safety of the device is only guaranteed if the device is connected to a properly
installed protective conductor system. Operations using an electrical outlet without a protective
conductor are prohibited. If in doubt, have the house installation checked over by a qualified
electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing or
damaged protective conductor.
Loading ...
Loading ...
Loading ...