Loading ...
Loading ...
Loading ...
12
2. Obtain desired water
1. Make sure the plug is connected to the wall outlet.
2. Place your cup on the removable drip tray, make sure it aligns with the spout.
3. First press about 3-5 seconds. and light up.
4. Press to choose your desired temperature and press
to set the water volume.
5. Press to operate the appliance. After 5-10 s, the desired water will flow out continuously
from water spout.
Press again, when your desired amount of water is obtained. The appliance will stop
working at once.
6. If you want to obtain water again, repeat the steps above.
Please note
► If device is not used for long periods of time there could be scale deposits despite water filter.
In this case let 3 oz with 212 °F run through the device.
► The appliance has a memory function if the plug is still plugged in. The settings, that were
adjusted the last time, are still adjusted. The settings will be reset after unplugging.
► The ambient temperature changes everyday. This leads to different amounts of water. It can
vary up to +- 15%.
3. Water disposal from the drip tray
1. When the drip tray is full, grasp and stabilize the appliance by
one hand and use the other hand to lift up the drip tray slightly
to remove it.
2. Empty the water tray and insert it into the original place. Make
sure it is properly inserted.
4. Replacing the filter
1. Open the tank cover and take out the box with the filter.
2. Soak the filter upright in water for 10 min.
3. Rinse the filter under running water for 10 sec.
4. Remove the old filter and replace it with a new filter (see fig.). Take out the filter box, place
the new filter and pull it down from the bottom.
A tank cover
B filter box
C filter
Loading ...
Loading ...
Loading ...