Loading ...
Loading ...
Loading ...
24 - INSTALLATION 91477A487/A
Positioning
Depending on the type of installation, this
appliance belongs to classes:
The appliance can be placed against walls that
are higher than the work surface, at a minimum
distance of X mm from the side of the appliance.
Any wall units installed above the appliance’s
worktop must be positioned at least Y mm from
it.
Levelling the appliance
The appliance must be level on the floor in order
to ensure greater stability.
After making the gas and electrical connections,
screw on the four legs supplied with the
appliance (1). Screw or unscrew the feet at the
bottom until the appliance is stable and level on
the floor (2).
Assembling the upstand (on some models
only)
The upstand must always be positioned and
secured correctly on the appliance.
1. Unscrew the two nuts (B) on the back of the
hob.
2. Position the upstand on the hob, taking care
to align the pins (C) with the holes (D).
3. Fasten the upstand to the hob using a
screwdriver to tighten the screws (A).
Electrical connection
General information
Check the mains characteristics against the data
indicated on the plate.
The identification plate bearing the technical
Rated flow rate G31 (g/h)
71 125 207 286 300 214
See General safety instructions.
Class 1 Free-standing
Class 2 - subclass 1 Built-in
X 100 mm
Y 750 mm
If a hood is installed above the
appliance, refer to the hood instructions
manual to make sure the correct
clearance is left.
See General safety instructions.
The upstand provided is an integral part
of the product. It must be fastened to the
appliance prior to installation.
See General safety instructions.
Loading ...