Loading ...
Loading ...
Loading ...
English
21
USING THE PROJECTOR
Powering on / o the projector
Freeze
Power Switch
L R
or
Powering on
1. Securely connect the power lead and signal/source cable. When connected, the Power LED will turn
red.
2. Turn on the projector by pressing the
button on the projector keypad or remote control.
3. A start up screen will display in approximately 10 seconds and the Power LED will be ashing blue.
Note: The rst time the projector is turned on, you will be prompted to select the preferred language, projection
orientation, and other settings.
Powering o
1. Turn o the projector by pressing the
button on the projector keypad or remote control.
2. The following message will be displayed:
Power O
Press power key again.
3. Press the button again to conrm, otherwise the message will disappear after 15 seconds. When
you press the button for the second time, the projector will shut down.
4. The cooling fans will continue to operate for about 10 seconds for the cooling cycle and the Power
LED will ash blue. When the Power LED turns solid red, this indicates the projector has entered
standby mode. If you wish to turn the projector back on, you must wait until the cooling cycle has
nished and the projector has entered standby mode. When the projector is in standby mode, simply
press the
button again to turn on the projector.
5. Disconnect the power lead from the electrical outlet and the projector.
Note: It is not recommended that the projector is turned on immediately, right after a power o procedure.
Loading ...
Loading ...
Loading ...