Loading ...
Loading ...
Loading ...
TROUBLESHOOTING
1. Please note: if a power failure occurs due to the disconnection of
the power cord, or the power button has been switched off during
an ice-making cycle, small ice chips may be formed and lodge in
the automatic shovel causing it to jam. The ice chips can be
removed by carrying out the following steps: first, disconnect the
power cord; next, gently push the shovel to the rear of the cabinet;
finally, restart the ice maker.
2. Please check if the water reservoir is flat when the ice shovel can
not remove the ice from the ice basket. If not, please push the ice
shovel gently by finger, then press the POWER button to restart.
PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTIONS
ressor works The comp
abnormally with a
buzzin g noise
The voltage is lower
than r ecommended
Stop the ice maker and do not
restart until the voltage is normal.
indicator
Water shortage
light is on
1.There is no water
2.The pump is full of air
1.Add to some water until it
reaches MAX position
2.Press POWER button to restart
Indicator lights on
display are not on
Blown fuse/ No power Replace fuse / Turn power on
large
sticking
The Ice made is too
and with pieces
together.
Ice of previous cycles
left in the water tray
Take out the ice under the
STANDBY mode.
The ice making
process
was correct,
but no ice came out?
1.
2.
The compressor
has no refrigerant
Compressor
damaged
Call the service hotline
10
Loading ...
Loading ...
Loading ...