Loading ...
Loading ...
Loading ...
Leveling Refrigerator
Swing Door Models
CAUTION
Protect soft vinyl or other flooring with cardboard,
rugs or other protective material to avoid property
damage.
If your refrigerator requires an ice maker water supply
connection, proceed to Connect ice maker water supply
section before leveling your refrigerator.
1. Plug in power cord.
2. Move refrigerator into final location.
3. Level refrigerator using a level placed on top of the
refrigerator.
• Remove toe grille(A). Remove bottom hinge
cover(B).
• Turn roller adjustment screws(C) to raise or lower
refrigerator cabinet. Front of refrigerator must be
%" (6 mm), or ½ bubble on your level, higher than
the back of your refrigerator.
• Make sure refrigerator cabinet is level from side to
side by adjusting left and right roller adjustment
screw(C).
Turn stabilizing leg (C) clockwise until firmly
against floor.
Replace toe grille(A) and bottom hinge cover(B).
See markings on inside of toe grille to insure
proper placement.
• Snap top portion into place first. Press down on
lower part of grille until bottom portion snaps into
place.
C
A
B
t
D
Pullout Freezer Drawer Models
CAUTION
Protect soft vinyl or other flooring with cardboard,
rugs or other protective material to avoid property
damage.
If your refrigerator requires an ice maker water supply
connection, proceed to Connect ice maker water supply
section before leveling your refrigerator.
1. Plug in power cord.
2. Move refrigerator into final location.
3. Level refrigerator using a level placed on top of the
refrigerator.
• Remove stabilizing leg covers (A). Remove toe
grille (B).
• Turn roller adjustment screws(C) to raise or lower
refrigerator cabinet. Front of refrigerator must be
%" (6 mm), or ½ bubble on your level, higher than
the back of your refrigerator.
• Make sure refrigerator cabinet is level from side to
side by adjusting left and right roller adjustment
screw (C).
• Turn both stabilizing legs (D) clockwise until firmly
against floor.
• Turn roller adjustment screws 2 to 3 times counter-
clockwise, so that full weight of unit rests on
stabilizing legs.
4. Replace toe grille (A) and both stabilizing leg
covers (B). See markings on inside of toe grille to
insure proper placement.
• Snap top portion into place first. Press down on
lower part of grille until bottom portion snaps into
place.
5. Review Installation Checklist in Owner's Manual with
consumer.
5. Review Installation Checklist in Owner's Manual with
consumer.
]0
Loading ...
Loading ...
Loading ...