Loading ...
SETTING THE CODE
1. Open the Touch C.ode Transmitter cover to access the key-
pad. Decide on a4-digit code number using numbers from
0 to 9. You can use a number more than once. (For
example, 4, 0, 4, 1).
2o Press the 'SR' code button on the opener panel. The
indicator light atongside the push button will turn ON.
3_ STAND AWAY FROM THE DOOR. Press the selected code
numbers on the keypad and then press the ENTER key.
The indicator light on the opener panel wiil turn OFF and
the door witl begin to move, The opener receiver has been ._
programmed with your code selection. (_
NOTE 1" If the indicator light turns OFF before the code _ . "_ _'
digits and ENTER key are pressed, repeat Steps 2 and 3. _._t,_-_ J t_
NOTE 2' During programming, be sure the,k/_ca_i_n push :---'-"_"
button (if your opener has that feature) is OFF and the
Infrared Sensor (if you have installed that accessory) is
free of obstruction. THE DOOR WILL NOT MOVE AND THE
INDICATOR LIGHT WILL NOT TURN OFF in either case.
To change your code at any time, repeat Steps 1, 2 and 3.
BATTERY: The 12 Volt battery should produce power for at
least one year. As long as there is adequate power, the key-
pad will illuminate and receiver will operate when code and
ENTER keys are pressed.
Replace the battery when keypad illumination becomes dim.
T
GARAGE DOOR OPENER RECEIVER
0&_ "SR'Code Button)
RED WHT BLK YEL
%
"1989, Sears Roebuck & Company
114At155 All Rights Reserved Printed in Mexico
Loading ...