Vacmaster VF408 1101 Operator’s manual

Loading ...

2 3 4 5 61

3 42

5 6

Installing Cartridge Filter

1. Verify that the power cord is disconnected from the outlet. (g. 1)

2. Remove power head and place in upside down position.

3. Install the cartridge lter over the lter cage and carefully push lter in until it stops against the

power head. (g. 2 & 3)

4. Place lter retainer on top of cartridge lter and tighten down by turning retainer clockwise. (g.

4 & 5)

Removing and Cleaning Cartridge Filter

1. Unlock and remove the lter retainer by turning retainer handle counter clockwise.

2. Carefully hold and pull the cartridge lter up for removal. (g. 6)

3. Clean the cartridge lter by gently tapping or brushing dirt off. Cleaning should not be done

indoors in living areas. For optimal performance a new lter is recommended.

4. Install cleaned or new lter as instructed above in steps 1 - 4 of Installing Cartridge Filter.

5. Wet lters should be removed and allowed to air dry for 24 hours before installing onto the lter

cage.

Installing and Cleaning HEPA Filter

1. Verify that the power cord is disconnected from the outlet. (g. 1)

2. Unlock the lter door by lifting the lock tab UP to the unlocked position and pull the door out. (g.

2 & 3)

3. Remove the HEPA lter cartridge from the vacuum. (g. 4)

4. Clean lter by brushing dirt off. For optimal performance a new lter is recommended. (g. 5)

5. Install the cleaned or new lter. (g. 6)

6. Insert the lter door tabs into the upper slots and lock the lter door into place. (g. 7 & 8)

INSTALLING & CLEANING CARTRIDGE

FILTER

Loading ...

Vacmaster VF408 1101 VF408 4 Gallon Wet/Dry Vacuum Cleaner with 2-Stage Motor