Loading ...
Loading ...
Loading ...
Installation
PROCEDURE C
D edirect the louvers at the back of the wall
sleeve to 60 ° angle as shown in the FIG 15.
The use of pliers is recommended.
7 13/1C
60_ ................... I__ 60°
Rear Louvers
(Top V ew)
FIG. 15
D f the wall sleeve already has a rear grille, skip
to step 4. If the wall sleeve does not have a
rear grille or Iouvered panel, install the plastic
grille from the kit. Cut the plastic grille to 26-
1/2" wide and 15-1/2" high. Place the plastic
grille to the inside of the wall sleeve at the rear
flange.
Place the plastic grille FIG. 16
Fasten the 4 washer screws to secure the
grille to the wall sleeve. If you need plastic nuts
to mount plastic grille to the inside of the wall
sleeve, there are plastic nuts in the installation
kit. The nuts are installed from the inside of the
sleeve and are pressed into the square holes
of the rear flanges.
or
Fasten the screws FIG. 17
D emove the backing from the Horizontal
Insulation strip 13/8 x 13/8 x 273/16 and attach
that to the inside bottom of the sleeve as
shown below. Remove the backing from the
Around Insulation strip 13/8 x 13/8 x 611/2 and
attach that to the inside front of the sleeve as
shown below.
FIG. 18
_lf the of sleeve is less than
depth your existing
or equal to 18", skip to step 7. Otherwise, cut
the baffles and the support blocks according to
Length "A" in the table below.
Depth"D" of the existing Length "A" ,_
- Support
wall sleeve (inches) (inches) _-/_ Block
18 <D_<18-5/8 3/4
18-% <D_<19-3/4 1 =3/4 T_I - Baffle
19-3/4<D_<22 4 _ FIG. 19
Q emove the backing from the support blocks
and attach them to the inside of the wall sleeve
as shown FIG 20. Slide the baffle into slots of
the support blocks
Support
Block
FiG. 20
16 Room Air Conditioner
Loading ...
Loading ...
Loading ...