Loading ...
Loading ...
Loading ...
RIP CUTS
(Optional attachment)
Rip cuts are easy to do with a straight edge
guide (Fig. 18). Straight edge guide is available
as an accessory. To attach, insert straight edge
guide, insert fence through slots in foot to
desired width as shown and secure with the set
screw.
FIG. 18
Set Screw
Desired
Width of Cut
Straight Edge
Guide
C
UTTING LARGE SHEETS
When making cuts longer than 2 feet in material
such as plywood, tool may become hot as well
as burn the material. To avoid this, let the tool
rest in between cutting.
Large sheets and long boards sag or bend,
depending on support. If you attempt to cut
without leveling and properly supporting the
piece, the wheel will tend to bind, causing KICK-
BACK and extra load on the motor (Fig. 15).
Support the panel or board close to the cut, as
s
hown in (Fig. 16). Be sure to set the depth of
the cut so that you cut through the sheet or
board only and not the table or work bench. The
two-by-fours used to raise and support the work
should be positioned so that the broadest sides
support the work and rest on the table or bench.
Do not support the work with the narrow sides
as this is an unsteady arrangement. If the sheet
or board to be cut is too large for a table or work
bench, use the supporting two-by-fours on the
floor and secure.
-16-
EDGE GUIDE
(Optional attachment)
The straight edge guide is used for cuts
parallel to the edge of the work, and can be
used from either side of the foot plate for
cutting on the left or right side of the material.
NOTE: When using the straight edge guide on
the left side or right side of the tool, position
guide as shown (Fig. 17).
FIG. 15 FIG. 16
WRONG
RIGHT
FIG. 17
2610049815 09-07-2017.qxp_US40 9/7/17 11:06 AM Page 16
Loading ...
Loading ...
Loading ...