Loading ...
Loading ...
Loading ...
45
ADVOCATE/BOULEVARD CLICKTIGHT User Guide
Table of Contents
Troubleshooting
Problem Possible Solution
The
CLICKTIGHT
will not close
with a click to
signal that
it is secure�
There may be debris or other objects
interfering with the mechanism.
Ensure the seat area is clear of any
obstructions and try closing the
CLICKTIGHT again.
There may be too much tension in
the belt/strap. Do not overtighten
the belt/strap before closing the
CLICKTIGHT. Only remove slack.
The logo on the
CLICKTIGHT dial
will not return
to a horizontal
position�
Press down again on the
CLICKTIGHT to the left and right of
the bezel to ensure the CLICKTIGHT
pins have fully engaged.
The harness
release button
will not operate�
There may be debris in the
mechanism. Clean the mechanism,
then try using the button again.
The harness
cannot be
adjusted to its
full height�
Check the seating position where
the child seat is installed. The vehicle
head restraint may obstruct the path
of the child seat harness height
adjuster. Remove or raise the vehicle
head restraint and try adjusting the
harness height again.
The harness
cannot achieve
a snug fit�
The harness can be adjusted to a
shortened length for use with small
infants (approx. 10 lbs and under).
See pages 23-24 for instructions on
adjusting the harness length.
The harness is
hard to adjust�
Check for harness twisting and
ensure that the comfort pads and
impact absorbing chest pads are
not interfering with the harness. Pull
comfort pads and impact absorbing
chest pads down.
The harness is
uneven�
Pull comfort pads and impact
absorbing chest pads down. Hold
harness straps up and away from
seat while closing the CLICKTIGHT.
The buckle will
not fasten with
a click after
each tongue is
inserted�
There may be debris in the buckle
mechanism. Clean the buckle (see
page 44), then try fastening the
buckle again.
Please contact Britax Consumer Services at 1-888-427-
4829 or 1-704-409-1699 if you have an issue not listed
here.
Loading ...
Loading ...
Loading ...