Loading ...
Loading ...
Loading ...
27
ADVOCATE/BOULEVARD CLICKTIGHT User Guide
Table of Contents
Overhang
It is important that the base of the child seat rests completely
flat on the vehicle seat with no side overhang. As seen in the
illustration, it is permissible to allow up to 3 in. (7.6 cm) of the
base to hang over the
front edge of the vehicle
seat. If the vehicle seat
does not allow enough
of the child seat base to
make contact, adjust the
recline angle to a more
upright position. Not
doing so could cause the
child seat to not perform
as intended.
In some cases, the vehicle head
restraint can prevent the child seat
head restraint from being raised
high enough to properly adjust the
harness for the fit of your child when
using a forward facing reclined
position. DO NOT force the child
seat head restraint past the vehicle
head restraint. Doing so could cause the child seat not to
perform as intended. If the location of the vehicle head
restraint interferes with the child seat head restraint, raise
or remove the vehicle head restraint. If the vehicle head
restraint cannot be removed, move the child seat to the
upright position or try a dierent seating location.
Uninstalling the Seat
1. Unbuckle the vehicle seat
belt.
NOTE: For car seats
installed with lower
connectors, see page
30.
2. Open the CLICKTIGHT.
Acceptable
Forward-Facing
Acceptable
Rear-Facing
3”
3”
Loading ...
Loading ...
Loading ...