Loading ...
Loading ...
Loading ...
Interconnecting wiring must be secured and protected from damage or disconnection. The use of
solderless connectors or equivalent is recommended. The low voltage control wiring exiting the
furnace is labeled "thermostat wiring".
SETTING THE HEAT ANTICIPATOR
The following method should be used in measuring the amp draw of the control circuit to assure
proper adjustment of the thermostat heat anticipator
,1
YELLOW PURPLE PURPLE
CONDENSER
FURNACE
\,
W
BLUE
I RATING THE FURN CE
WHITE
This furnace is ship!c G
__ n the factory equipped for u ._!ith nat;,ra! r RED uctions are
for use with natura THERMOSTAT es up to 2,000 feet, using a heating va GREEN 3tu/hr. Should
this appliance be converted to LP, refer to the instructions included in ne tactory a_ithorized LP
Conversion Kit (LPM-01). If for use at altitudes in excess of 2,000 feet refer to the instructions
included in the factory authorized High Altitude Kit (HA-02).
It is imwrap the'"R" leg around'a ciip-on'he input rate of the furnace to prevent an overfiring situation.
Overfilamp meter 10 times. It exchanger failure. The input is controlled bytLhe supply
pressLEnergize the furnace in the ;sure and heating (calorific) valu_"X
The SLheat mode. Record the reading, ured with _o _ o,,,4 - u,__urnina aDI31_ \\in\_,
st be adju_dt th_"se o e pressur_ /_eries and
.Divide this
reading by
°perat 10. Set the heat anticipator ,_Sin exc _ _ J" Ure an fice_ on //" /t"
rating onthe thermostat to match table belo_rate is 4%° for e_,\ /)ooThefeet
above°rifice_thisEXAMPLE:reading Jupon a heat_o proximately 1,C"\\ /z'ft3
If the reading on the amp meter is
"4", divide this by 10. __
The anticipator setting will be .4 NAT. GAS ORIFICE SI;
amps. #45
#47
#47
I 5,000 #47
IO-151 13
1
Loading ...
Loading ...
Loading ...