Loading ...
Loading ...
Loading ...
9
www.bromicheating.com
INSTALLATION INSTRUCTIONS CONTINUED...
4. Attach Heater to Wall Bracket/Control Housing
• Remove Front Cover from Control Housing
• Attach Heater to Wall Bracket/Control Housing
by inserting Mounting Arm into lower channel of
Wall Bracket. Ensure that the Gas Hose and Wiring
Harness slide through the groove on top side of
the control Housings lower channel and remain
undamaged by the metals edges during assembly.
• It may be necessary to manipulate the gas Hose so
that the arm can slide into place.
TIP: Do not install the mounting pin at this point.
• Spray soapy water on the arm to ease the sliding.
5. Connect the AGA approved flexible connector to the
Gas Valve Outlet Fitting
• Position heater and hose so that the gas hose and
fitting are in alignment
• NOTE: ensure that the hose nut and valve fitting are
parallel to one another and threads are engaged
correctly before tightening! Incorrect installation can
cause gas leaks and damage components.
TIP: Sliding the mounting arm inside the control
housing’s channel can help accurately Position the Gas
hose in place under the gas valve’s fitting.
• Spanner Tighten using 2 wrenches, and leak test
using soapy water (see section “leakage test”)
Loading ...
Loading ...
Loading ...