Loading ...
Loading ...
3
3
CZHVW30EX
www.comfortzoneproducts.com
Oscillation and Speed Control: While facing the fan, pull
the left string for oscillation and pull the right string for speed
setting. The fan will cycle through the following speed settings:
• OFF
• LOW
• OFF
• HIGH
To Adjust Airflow Upward Or Downward:
Loosen the position screw first and then loosen the pivot nut.
Tilt motor to the desired angle then firmly tighten the pivot nut
first and then tighten the position screw.
Installation Instructions
The wall fan must be mounted on 12 inch (300mm) thick dry and
cement ‑ grouted firm wall or on 4 by 5 inch wood studs / joists.
Use wall bracket as a template for locating the holes
to be drilled.
After determining the hole locations, use an appropriate sized
drill bit and, drill holes through mounting surface.
It is recommended that a minimum of grade 5 fasteners be
used. The following are acceptable surfaces for mounting wall
mount assembly.
STEEL SURFACE ‑ When mounting to a steel surface, such
as vertical I‑beam, drill through holes at pre‑marked locations,
using a 9/32" drill bit. Attach wall mount assembly to mounting
surface using 1/4"‑20 hex screw, in combination with 1/4" flat
washers, 1/4" lock washers, and 1/4"‑20 hex nuts.
MASONRY SURFACE ‑ When mounting to a masonry surface
use a 1/4" expansion type bolt or 1/4" masonry lag with shield.
Drill holes at pre‑marked locations using appropriate sized drill
bit as recommended for fastener.
NOTE: HARDWARE NOT SUPPLIED
Assembly Instructions:
1. Install the wall bracket following Installation Instructions.
2. Install the fan motor on the angle support bracket.
3. Assembling the back guard, blade, font guard to the motor.
Usage:
Fan operation: Always operate the fan in the upright position
following all instructions and recommendations listed in this
manual.
Fan connection: Plug fan directly into 120 volt A.C., 60 Hz
wall outlet. Be sure plug fits tightly in outlet. A loose connection
may cause overheating and damage to the plug or fan.
Note: To prevent overloading a circuit, do not plug the fan into
a circuit that is servicing other electrical needs.
Care and Maintenance
Cleaning: CAUTION‑Before cleaning the fan be sure to
disconnect power cord from the plug. Clean the grille surface
with a clean damp cloth. Do not use harsh chemical or abrasive
cleaners. DO NOT IMMERSE THE FAN OR ANY WIRES IN
WATER. Replace front grille before fan use. Allow fan to dry
completely before use. Periodic grille cleaning with a vacuum
will prevent dust build up. The motor is sealed and does no
require any interior maintenance, cleaning or lubrication.
Maintenance: The internal motor bearings are permanently
lubricated at the factory and do not require any additional
lubrication.
Repair: DO NOT OPERATE THE FAN WITHOUT THE GRILLE
IN PLACE. DO NOT USE THE FAN IF IT HAS MALFUNCTIONED
OR BECOME DAMAGED IN ANY WAY.
Storage: Keep original carton for storage of the fan. Coil and
tie the power cord to avoid damage during storage.
Wattage
Low High
185W 220W
Voltage Frequency
120V 60Hz
Max. Amperage
1.8A
Recommended Extension
Cord Gauge
16 AWG
Specifications
Loading ...